Your kinetic sculpture is made entirely of stainless steel and will maintain it’s luster for years and years.
Sculpture Installation
Replace bearing then lock collar leaving a 1/16 inch gap of play so blade turns freely. Tighten lock collar with a 1/8 inch Allen Wrench. Repeat procedure on opposite side making sure that the blades are turning in opposite directions.
If you plan to attach your sculpture to a building of any kind it will have to be electrically grounded just like a weather vane or lighting rod.
For best results put sculpture at least 8 ft off the ground in open breezy area away from trees and other wind blockers.
Your new piece of kinetic sculpture is made of stainless steel and will retain its luster for years. The blades have been balanced and should not be bent in any way. The plastic bushings are self-lubricating and self-cleaning, please do not add lubricant to them.
Print the instructions : Installations Instructions2014
Paradox Installation
Slide bearing shaft into sleeve. Stop when the top bearing is flush with top of sleeve.
Do not make the alen screws too tight! Turn them 1/2 turn and then spin the sculpture to see if it turns freely if it does turn them 1/4 turn more.
Print the instructions : Paradox Instructions
